What Is The Safety Factor Of Alloy Steel Shackles?

Oct 15, 2025

Leave a message

steel shackles are typically four, five, six times safer, and some special models (such as super shackles) can be up to eight times safer.
I. Definition and Function of Safety Factor
The safety factor is the ratio of the ultimate work load of a shackle to its rupture load, reflecting its safety reserve capacity when the rated load is exceeded. For example:
6 times the safety factor: If the shackles have a maximum working load of 10 tons, their breaking load must be at least 60 tons to ensure that they do not break suddenly in the event of accidental overload.
Higher safety factor (e.g. 8 times): Suitable for extreme working conditions (e.g. deep sea operations and nuclear power equipment lifting), more reliable.
ii. Classification Alloy Steel Shackle Safety Factors
General Shackles
Safety factor: 4x or 6x
Uses: general lifting operation, such as shipbuilding, construction, logistics, etc..
For example, for Type D shackles with a rated load of 5 tons, if the safety factor is 6x, the fracture load must be ≥ 30 tons. According ISO 2415: 2022 2022, the safety factor for American Standard G-210 shackles (alloy steel) is normally 6.
High-Strength/Super Shackles
Safety factor: 8
Application: Extreme working conditions or high-risk areas (such as oil platforms and heavy machinery manufacturing).
Example:
The Swedish GUNNEBO super shackle are eight times safer and can withstand 1,200 tons of load.
Some straight-chain alloy steels,such as those with more than 50 tons of straight-chain alloy, use a factor of five safety to balance strength and cost.
III. Factors affecting security
Materials and processing
Alloy steels (e.g., 40Cr and 20CrMnTi): Tempering heat treatment (tensile strength ≥ 800 MPa) improves material toughness and supports higher safety factors.
Forging process: Die forging locking internal structure than casting locking density, fatigue resistance, suitable for high safety factor design. Working environment
Temperature Impact:
When the temperature exceeds 200°C, the rated load must be reduced according to the standard (e.g., 90% of the original load capacity at 200°C-300°C).
For low temperatures (below -40°C), brittle fracture materials should be used to prevent loss of safety factors.
Corrosive Environments: Galvanized or Dacromet-coated materials can be tested for 48 hours or more in salt mist to prevent loss of strength due to rust.
Load Types
Dynamic Loads: Crane swing and impact loads require a high safety factor (e.g. 6 times or more).
Static Loads: Lower safety factor (e.g. 4x) may be used for hoisting of fixtures.
IV. INTRODUCTION Guide: How to Select the Appropriate Shackle Safety Factor
Assessment of risks to Working Condition
For high-risk scenarios (e.g., high-altitude work, flammable and explosive environments): safety factor 8 times higher than priority.
For low-risk scenarios (e.g. warehouse cargo handling): a safety factor of 4x or 6x is sufficient.
Reference to industry standards
ISO 2415:2022 provides for a lockdown safety factor of 4 times or more, with a safety factor of 6 times recommended for general lifting. GB/T25854-2010: China's national standard require the lock to have a fracture load of at least four times the rated load.
Check product labeling.
Normal shackles shall be accompanied by rated loads, safety factors and construction criteria (e.g. EN 13889 or ASME B30.26).
Avoid using unlabeled or poorly labeled products to avoid accidents caused by overloading.

Send Inquiry